While the bricks and blocks heavy clay use the gifts of stocks, being cut and burned from 8 to 12 medium sized trees for healing and send toxic gases in the atmosphere, leading to global warming.

Bricks and blocks to ecological land use (SOIL-CEMENT, INDUSTRIAL WASTE AND CONSTRUCTION) preserve the stocks, don't burn nor cut the trees.
The ecological ones are pressed, do not pollute the environment and their healing process uses little water, and all that humidity evaporates and returns clean to the atmosphere.

The healing system of Blocks, Bricks and Eco Floors is by wetting (wetting) that can be done by sprinkling manual, mechanized, automated and immersion. But it is important to note that in any of the alternatives listed above, you should keep the parts moist curing for 7 days.

NORMAL MANUAL WATER SYSTEMS (CURE):

The healing waters sprinkling manual should occur in a preferably covered with protection from rain, sun and wind so that excessive moisture does not evaporate prematurely. This method can be done through the hose, watering and other similar objects, occurring at least 03 (three) times a day. When you start this process of water shall be of the thin and light drizzle, taking care to that in the early hours of the added water on the product is not too strong not to affect its quality.

If wetting is strong, it tends to cause even minor defects, their faces may be harsher, but also somehow affect their strength, taking a bit of Compression applied to the product. After a dozen hours after the onset of healing, Blocks and Bricks Ecological gain more resistance, thus the addition of water could increase gradually getting even stronger. One must always worry about quality, so it should not miss the product moisture pressed.

Note: The pieces should be kept moist through successive wettings every two hours. This can vary depending on the type of soil used, be aware of the considerations mentioned.

SYSTEM WATERS (CURE) MECHANICAL AND AUTOMATIC.

MECHANICAL:

The healing waters sprinkling mechanized can be done by spray nozzle (used to poison or go to water in poultry houses, and others), a kind of system of water mist. The process occurs through hoses or pipes high and distributed several sprinkler fixed and adjusted so that it is on the product to be dampened when the record open network vaporize water penetrating slightly in Block, Brick or ecological floors. This is a cheap and easy to install, which dispenses be watering. It should occur at least 3 times a day.

AUTOMATIC:

It is basically the same system of mechanized, the difference is the acquisition of a humidity sensor and heat (no humidity), which is triggered automatically as adjusted, to keep moisture where necessary (wet

SYSTEM WATERS BY IMMERSION:

In a flat area covered and after pressing, the manufactured products should be stored on pallets to a maximum height of 1.5 meters for healing, this stack should be firm for drives for cars, forklifts, cranes, crane, among others. After they are stacked and pressed, if the product is drying quickly, should be slightly wet after a dozen hours of compression (pressing).

Blocks and ecological bricks will be immersed (dipped) in a tank for about 2 minutes each so they are totally soaked with water, then you should lift the pallet leaving the tank to drain excess water and make the packaging them in a space. It should cover the product with black plastic, preferably to be impervious to moisture, for a period of approximately 7 days after this process and withdraw from the canvas if needed, leave on time.

This is a system with the cost a little higher demand for more equipment to transport and process, but is considered more efficient for reducing the time and final product quality, to let the moisture always uniform. Even if the process evaluated positively, it is less used by requiring greater financial contribution.